Validating identity on wireless network

When you repair a wireless connection, it is disabled and re-enabled, which clears many error conditions on wireless network adapters.When a wireless client running Windows XP with SP2 or Windows Server 2003 with Service Pack 1 attempts a wireless connection, it goes through the following authentication states, which are indicated as the status of the wireless connection in the Network Connections folder, and in the new wireless connection Status dialog box, and in the Wireless Network Connection dialog box: Once authentication has succeeded, a wireless client running Windows XP with SP2 or Windows Server 2003 with Service Pack 1 then attempts to obtain a valid IP address configuration and goes through the following states, which are indicated as the status of the wireless connection in the Network Connections folder, and in the new wireless connection Status dialog box, and in the Wireless Network Connection dialog box: These improvements give the user and the network troubleshooter more information about how the wireless connection is progressing, from the initial association to the allocation of a valid IP address.For detailed information about a Windows-based authentication infrastructure, see Wireless Deployment Technology and Component Overview.For detailed information about how to deploy a wireless LAN using IEEE 802.1X authentication, see Deployment of Protected 802.11 Networks Using Microsoft Windows.

Additionally, when you obtain status on the connection, you can view the signal strength on the General tab and the IP address configuration on the Support tab.

For Windows XP with SP1, Windows XP with SP2, Windows Server 2003, or Windows 2000 with SP4, you can specify the names of the servers that must authenticate the wireless client in Connect to these servers, from the properties of the Smart Card or other Certificate EAP type, available from the Authentication tab for the properties of a wireless network.

The names of the servers must match the names of the authenticating servers or authentication will fail.

To obtain detailed information about the Wireless Zero Configuration service for Windows XP SP2 or Windows Server 2003 with Service Pack 1 and the EAP authentication process for all versions of Windows XP or Windows Server 2003, you must enable tracing by typing netsh ras set tracing * enabled at a command prompt.

To obtain detailed information about how the Wireless Zero Configuration service connected to a wireless network for computers running Windows XP with SP2 or Windows Server 2003 with Service Pack 1, try the wireless connection again and view the and files in the \Tracing folder.

Leave a Reply